Technical features
This system is suited for new or existing pools. The spindle is located above the water level and housed in a benchlike structure that conceals the cover. The structure is robustly constructed from consoles bolted to the pool copings and profiles in aluminium. The motor that winds and unwinds the cover is located inside the spindle (above ground, in roller motor). The aluminium housing is supplied in either grey or white. The cover is operated automatically by using a key switch and the limits are programmed electronically.
For pools up to 6m x 15m. The dimensions of the bench depend on the cover length:
- Cover up to 10m: 620mm x 585mm (width x height)
- Cover between 10m & 15m: 720mm x 685mm (width x height)
Components:
- The following elements are included in the drive system:
- Spindle made to measure in stainless steel
- Aluminium bench in white (RAL 9003), light grey (RAL 9006) or dark grey (RAL 9007)
- Optional wooden top
- Edge Motor 24V DC
- Edge 120 – IPX5 – 120 Nm – 3 rpm
- Control panel IP55, including safety transformer and circuit board
- Integrated key switch IP54 with open and close functions
- Set of straps
- Set of directional guides
